Charger V6-3.5L (2009)
5. Remove any clips (2) retaining brake rotor (3) to wheel mounting studs.
6. Slide brake rotor (3) off hub and bearing (1).
Front
FRONT
NOTE: Inspect brake pads before installation. See: Brake Pad/Service and Repair/Procedures/Brake Pads - Inspection
1. Clean hub face (1) to remove any dirt or corrosion where rotor mounts.
2. Install brake rotor (2) over studs on hub and bearing.
3. AWD - Install disc brake caliper and adapter assembly (2) over brake rotor.
4. AWD - Install mounting bolts (1) securing caliper adapter (2) to knuckle (3). Tighten bolts to 95 Nm (70 ft. lbs.).