Charger V6-3.5L (2009)
CAUTION: A burnish procedure must be performed anytime NEW brake pads or rotors are installed on a vehicle equipped with the Police
Package. This procedure is particularly important in situations where high speed pursuit is a possibility. It is recommended that
the procedure be performed by the Police agency operating the vehicle so it can be performed in a safe controlled environment.
This information is covered in the Police Package Owners Manual Supplement which was supplied when the vehicle was originally
delivered.
11. Road test vehicle making several stops to wear off any foreign material on brakes and to seat brake shoes. If the vehicle is equipped with the
Police Package, a burnish procedure must be followed (Refer to preceding Caution).
Rear
REAR
NOTE: Inspect disc brake pads and parking brake shoes before installation. See: Brake Pad/Service and Repair/Procedures/Brake Pads -
Inspection
1. Clean hub (1) face to remove any dirt or corrosion where brake rotor mounts.
2. Install brake rotor (3) over wheel mounting studs and onto hub (1).
3. Install disc brake caliper and adapter assembly (3) over brake rotor.
4. Install mounting bolts (1) securing caliper adapter (3) to knuckle (2). Tighten bolts to 115 Nm (85 ft. lbs.).