Charger V6-3.5L (2009)
Lateral Accelerometer: Service and Repair
Dynamics Sensor - Installation
INSTALLATION
1. Install dynamics sensor (3) over studs mounted to floor pan tunnel (4).
2. Install mounting nuts (2). Tighten nuts to 12 Nm (110 in. lbs.) torque.
3. Connect wiring harness (1) connector to module (3).
4. Install floor console. See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor Console - Installation
5. Connect battery negative cable (2) to battery post. It is important that this is performed properly. See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery Reconnection
6. Perform Verification Test and clear any faults See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests.