Charger V6-3.5L (2009)
Bearing caps are not interchangeable and are marked to insure correct assembly. Upper and lower bearing halves are NOT interchangeable.
CAUTION: Main bearings are select fit. See: Procedures
NOTE: Only one main bearing should be selectively fitted while all other main bearing caps are properly tightened.
When installing a new upper bearing shell, slightly chamber the sharp edges from the plain side.
1. Lubricate main bearing (4) with clean engine oil.
2. Start bearing (4) in place, and insert Main Bearing Tool C-3059A (3) into oil hole of crankshaft.
3. Slowly rotate crankshaft counterclockwise sliding the bearing into position. Remove Main Bearing Tool C-3059A.
NOTE: Lubricate main bearing cap bolts with engine oil before installation.
4. Lubricate and install lower bearing half and main cap Tighten bolts finger tight.
