Charger V6-3.5L (2009)
HOUSING-FRESH AIR INLET
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Service
Precautions/Warning and See: Service Precautions/Caution . Failure to follow these instructions may result in possible serious or
fatal injury.
NOTE: The fresh air inlet housing must be removed from the vehicle for removal of the HVAC housing.
NOTE: LHD model shown in illustrations. RHD model similar.
1. Disconnect and isolate the negative battery cable.
2. Remove the cowl top panel from the dash panel See: Body and Frame/Cowl/Cowl Moulding / Trim/Service and Repair/Cowl Panel Cover -
Removal.
3. Remove the two bolts (1) that secure the strut support (2) to the driver side strut tower (3).
4. Disengage the wiper motor (5) from the bracket (4) located on the strut support.
5. Disengage the retainer that secures the wire harness (4) to the bottom of the strut support (3).
6. On LHD models, remove the purge solenoid (5) from its mounting bracket and position the solenoid out of the way.
7. Remove the two bolts (1) that secure the strut support to the passenger side strut tower (6) and remove the support from the engine compartment.
8. Position the powertrain control module (PCM) or the engine control module (ECM) (2) (depending on engine application) out of the way.