Charger V6-3.5L (2009)
5. Install a new gasket between the EGR valve (3) and the EGR tube. Install the bolts (1) and tighten to 15 Nm (11 ft. lbs.).
NOTE: The EGR tube flange (1) does not need to be flush with the intake manifold (2) to be sealed. The EGR tube flange can be up to 2 mm
(0.08 in.) from intake manifold and still be sealed. This design allows the EGR tube position to vary with the tolerance stack up and
remain properly sealed.
6. Connect and lock the electrical connector to EGR valve.
7. Verify that no wiring harnesses or hoses are contacting the EGR tube.