Charger V6-3.5L (2009)
7. Connect and lock the electrical connector to EGR valve.
8. Verify that no wiring harnesses or hoses are contacting the EGR tube.
9. Install the purge solenoid to its mounting bracket.
10. Install the strut tower support (6) with four bolts. Tighten the bolts to 20 Nm (15 ft. lbs.).
11. Install the wiper module and cowl panel (1) See: Wiper and Washer Systems/Wiper Motor Linkage/Service and Repair/Wiper Arm Linkage -
Installation.
12. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lbs.).
13. Using a scan tool, erase any previously recorded Diagnostic Trouble Codes (DTCs).