Charger V6-3.5L (2009)
3. Reconnect the seat wire harness (1) connector to the seat airbag inflator. Be certain that the connector latches and lock are fully engaged.
4. Reinstall the trim onto the front and back of the front seat back. See: Body and Frame/Seats/Seat Cover/Service and Repair/Seat Back Cover -
Installation
5. Reinstall the front seat into the vehicle. See: Body and Frame/Seats/Service and Repair/Seat, Front/Seat - Installation
WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. PERSONAL INJURY OR DEATH MAY RESULT IF THE
SYSTEM TEST IS NOT PERFORMED FIRST. FOR THE SYSTEM TEST, See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Supplemental Restraints
Verification Test
Driver Air Bag Cover - Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service.
Failure to do so may result in accidental airbag deployment, personal injury or death.
CAUTION: Do not pull on the horn switch feed pigtail wire to disengage the connector from the driver airbag or to disconnect the horn switch
to steering wheel wire harness connection. Improper pulling on this pigtail wire or connection can result in damage to the horn
switch membrane or feed circuit.
2. Remove the driver airbag (2) See: Driver Air Bag - Removal.
3. With driver airbag removed, pick a corner and push down on the inflator (1) or latch hook mounting plate until the latch hooks (2) push out of the
driver airbag cover (3).
4. Remove driver airbag from driver airbag cover.
5. The membrane type horn switch is integral to the driver airbag trim cover. If inoperative, the entire trim cover must be replaced.
