Charger V6-3.5L (2009)
6. Remove the left side fuel pump module rubber access plug.
7. Disconnect the electrical connector from the fuel pump module.
CAUTION: An indexing arrow is located on top of the fuel pump module to clock it's position into the fuel tank, note it's location for
reassembly.
NOTE: Prior to removing the fuel pump module, use compressed air to remove any accumulated dirt and debris from around fuel tank
opening.
8. Position the lock ring remover/installer 9340 (1) into the notches on the outside edge of the lock ring.
9. Install a 1/2 inch drive breaker bar into the lock ring remover/installer 9340 (1).
10. Rotate the breaker bar counterclockwise and remove the lock ring.