Charger V6-3.5L (2009)
Alternator: Service and Repair
Generator - Removal
3.5L
WARNING: DISCONNECT NEGATIVE CABLE FROM BATTERY BEFORE REMOVING BATTERY OUTPUT WIRE (B+ WIRE) FROM
GENERATOR. FAILURE TO DO SO CAN RESULT IN INJURY OR DAMAGE TO ELECTRICAL SYSTEM.
1. Disconnect and isolate negative battery cable at battery.
2. Remove generator drive belt, See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and
Repair/Removal and Replacement/Serpentine Accessory Drive Belt - Removal.
3. Remove upper most mounting bolt (2) from generator (1).
4. Remove generator bracket bolt (3) and remove bracket (4).
5. Unsnap plastic protective cover (3) from B+ mounting stud.
6. Remove B+ terminal mounting nut (2) and B+ terminal (1) at rear of generator.
7. Disconnect field wire electrical connector (4) by pushing on connector tab.
