Charger V6-3.5L (2009)
CAUTION: In following step, use care not to damage ball joint seal boot while sliding Puller, Special Tool 9360, into place past seal boot.
14. Using Puller (2), Special Tool 9360, separate upper ball joint stud (1) from knuckle.
15. Remove tool.
16. Remove nut (1) from end of upper ball joint stud.
17. Slide knuckle (3) off half shaft (1) and remove from vehicle.
18. If hub and bearing and dust shield need to be removed:
a. Remove four bolts (3) fastening hub and bearing (2) to knuckle.