Charger V6-3.5L (2009)
2. Place knuckle (3) over lower ball joint stud and guide hub and bearing (2) onto axle half shaft (1).
3. Start NEW nut (4) on lower ball joint stud. Do not tighten at this time.
CAUTION: It is important to tighten nut as described in following step to avoid damaging ball stud joint.
4. Place upper ball joint stud (1) through hole in top of knuckle and install nut (4). Tighten nut by holding ball joint stud with a hex wrench while
turning nut with a wrench. Tighten nut using crow foot wrench on torque wrench to 47 Nm + 90° turn (35 ft. lbs. + 90° turn).
CAUTION: It is important to tighten nut as described in following step to avoid damaging ball stud joint.
5. Tighten lower ball joint nut (4) by holding ball joint stud with a hex wrench while turning nut with a wrench. Tighten nut using crow foot wrench
