Charger V6-3.5L (2009)
NOTE: If a lengthwise paint stripe appears on the return hose (3) near the end, position that paint stripe at the top (12 O'clock position) when
installed on the cooler. This positioning must be done to ensure proper hose routing.
3. Slide return hose (3) onto end of cooler (1). Install clamp securing hose in place.
4. Slide return hose (1) onto reservoir (2). Install clamp securing hose in place.
5. Install upper radiator closure panels.
6. Install air cleaner housing and inlet tube. See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner
Housing/Service and Repair/Air Cleaner Body - Installation
7. Connect battery negative cable (2) to battery post. It is important that this is performed properly. See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery Reconnection
8. Fill and bleed power steering system. See: Service and Repair/Power Steering System Bleeding
Supply Hose
INSTALLATION