Charger V6-3.5L (2009)
8. Export Only - If servicing right spring link, connect headlamp leveling sensor (1) link at spring link (3).
9. Install rear spring as well as all components necessary to access it. See: Suspension Spring ( Coil / Leaf )/Service and Repair/Rear Suspension -
Coil Spring(s) - Installation
10. Lower vehicle.
11. Position vehicle on alignment rack/drive-on lift. Raise vehicle as necessary to access mounting bolt.
12. Tighten spring link bolt at crossmember to 108 Nm (80 ft. lbs.) torque.
13. Perform wheel alignment. See: Alignment/Service and Repair
Rear Tension Link - Removal
REMOVAL
1. Raise and support vehicle. See: Wheels and Tires/Vehicle Lifting/Service and Repair
2. On both sides of vehicle, remove wheel mounting nuts (3), then rear tire and wheel assembly (1).