Charger V6-3.5L (2009)
Rear Knuckle Alignment Link: Service and Repair
Rear Camber Link - Installation
INSTALLATION
NOTE: When installing link (1), ensure following to avoid mis-installation:
-
Heavier, thicker end goes toward crossmember.
-
Fore-or-aft bow faces forward (curves around coil spring).
-
Up-or-down bow faces downward.
1. Place link in bracket on crossmember (1). Install bolt and nut (2) at crossmember (1) as shown. Do not tighten bolt at this time.
2. Install bolt and nut (2) mounting link to knuckle (3) as shown. Do not tighten bolt at this time.