Charger V6-3.5L (2009)
4. If equipped, Attach wheel speed sensor cable (2) to toe link.
5. Carefully raise jack, guiding coil spring and lower end of shock absorber (4) into mounted positions.
6. When lower shock mounting bolt holes line up install bolt (2) and nut (4). Do not tighten at this time.
NOTE: Rear crossmember mounting bolts (2) are longer than front mounting bolts (3). Do not interchange mounting bolts.
7. Continue to raise crossmember in not already in mounted position, then install crossmember mounting bolts (2 and 3). Snug, but do not fully
tighten bolts at this time.