Charger V6-3.5L (2009)
Fluid Pressure Sensor/Switch: Service and Repair
Transmission Solenoid and Pressure Switch Assembly - Removal
REMOVAL
NOTE: If the Solenoid/Pressure Switch Assembly is being replaced, the Quick Learn Procedure must be performed. See: Powertrain
Management/Computers and Control Systems/Engine Control Module/Service and Repair/Procedures/TCM Quick Learn
1. Raise vehicle on hoist.
2. Remove valve body assembly from transmission. See: Valve Body/Service and Repair/Removal and Replacement/42RLE Automatic
Transmission/Valve Body - Removal
3. Remove Solenoid/Pressure Switch Assembly retaining screws (2) from solenoid.
4. Remove Solenoid/Pressure Switch Assembly (1) and screen from valve body (2).