Charger V6-3.5L (2009)
9. Lower vehicle
10. Tighten the shift cable adjustment screw (5) to 7 Nm (65 in.lbs.).
11. Verify correct operation.
12. Install any floor console components removed for access. See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor
Console - Installation
Shift Cable - Column Mount
GEARSHIFT CABLE - COLUMN MOUNT
Check adjustment by starting the engine in PARK and NEUTRAL. Adjustment is CORRECT if the engine starts only in these positions. Adjustment is
INCORRECT if the engine starts in one but not both positions. If the engine starts in any position other than PARK or NEUTRAL, or if the engine will
not start at all, the park/neutral position contact may be faulty.
1. If necessary, remove the instrument panel side trim at the end of the instrument panel.
2. If necessary, remove the knee bolster fasteners.
3. If necessary, disconnect the trunk release harness connector to the trunk release switch on the knee bolster, and remove the knee bolster.
4. If necessary, remove the screws (3), and remove the instrument panel steering column cover reinforcement (1).
5. If necessary, remove the silencer panel fasteners, and remove the silencer panel (1).
6. Shift transmission into PARK.
