Charger V6-3.5L (2009)
3. Install the Torx(R) socket bolts (3) and torque to 8 Nm (71 in.lbs.).
4. Install a new oil filter (4).
5. Install oil pan (5) and torque the oil pan bolts to 8 Nm (71 in.lbs.).
6. Install the adapter plug (10) into the transmission housing and tighten the bolt (9) to 2.5 Nm (22 in.lbs.).
7. Check O-ring on plug connector (1), and replace if necessary.
8. Install the plug connector (1) into the adapter plug (2). Turn bayonet lock of adapter plug (2) clockwise to connect plug connector (1).
9. Fill the transmission with the correct oil See: Service and Repair/Procedures/NAG1 Automatic Transmission/Transmission Fill using the standard
procedure . See: Service and Repair/Procedures/NAG1 Automatic Transmission/Fluid/Filter Service
Valve Body - Removal
REMOVAL
NOTE: If valve body is being reconditioned or replaced, it is necessary to perform the Quick Learn Procedure.See: Powertrain
Management/Computers and Control Systems/Engine Control Module/Service and Repair/Procedures/TCM Quick Learn