Charger V6-3.5L (2009)
20. Install the electrohydraulic control module (12) onto the shift plate (13).
21. Bend the retaining lug on stiffening rib on transmission oil temperature sensor to retain the electrohydraulic control module.
22. Install the solenoid valves (6 - 11) into shift plate (13).
NOTE: Check O-rings on solenoid valves for damage and replace if necessary.
23. Install the leaf springs (5).
24. Install the Torx(R) socket bolts (3, 4). Tighten the bolts to 8 Nm (71 in.lbs.).
NOTE: Pay attention to the different lengths of the Torx(R) socket bolts.
25. Install the solenoid caps (1, 2) if equipped.
26. Install the electrohydraulic unit into the vehicle.
Valve Body - Disassembly
DISASSEMBLY
NOTE: If the valve body is being reconditioned or replaced, it is necessary to perform the Quick Learn Procedure using the scan tool See:
Powertrain Management/Computers and Control Systems/Engine Control Module/Service and Repair/Procedures/TCM Quick Learn
1. Remove the electrical connectors from the pressure control solenoid (1) and the line pressure sensor (2).
2. Remove the screws (6) holding the pressure control solenoid (1) and line pressure sensor (2) to the valve body.
3. Remove the pressure control solenoid and line pressure sensor from the valve body.
4. Remove the shoulder screw (3) holding the variable line pressure header (4) to the valve body.
5. Remove the variable line pressure header from the manual shaft (5).