Charger V6-3.5L (2009)
Transfer Case Clutch: Service and Repair
Clutch Coil - Removal
REMOVAL
1. Remove the transfer case See: Service and Repair/Removal and Replacement/BW 44-40 Transfer Case - Removal.
NOTE: The vent hole is near the input shaft hub. If the unit is set on the mounting surface, oil will drain out through the vent.
2. Place the transfer case so that it can be drained of any remaining fluid and remove the drain plug (2).
3. Install Holder 6958 (1) onto the rear output flange (2).
4. Remove the rear output flange nut.
