Charger V6-3.5L VIN G (2006)
Do not tighten nut at this time.
4. If equipped, Attach wheel speed sensor cable (2) to toe link.
5. Raise rear exhaust back to mounted position and connect exhaust isolators at muffler and resonators hangers. Remove jack or stand below exhaust
muffler.
6. Install tire and wheel assembly (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.) torque.
7. Lower vehicle.
8. Position vehicle on alignment rack/drive-on lift. Raise vehicle as necessary to access mounting bolts.
9. Tighten toe link (1) fasteners to:
^
Nut at crossmember - 108 Nm (80 ft. lbs.) torque (This nut may be tightened after rear wheel alignment toe is set. Do not tighten from bolt
