Charger V6-3.5L VIN G (2006)
a. Slide shield onto rear of hub and bearing.
b. Slide hub and bearing into knuckle, lining up mounting holes in hub and bearing with those in shield and knuckle
c. Install four bolts (3) fastening hub and bearing in place. Tighten mounting bolts to 68 Nm (50 ft. lbs.) torque.
NOTE: Before installing hub and bearing on end of axle half shaft, ensure isolation washer is present on end of half shaft. Inspect washer
making sure it is not worn or damaged. Washer can be installed in either direction on shaft.
2. Place knuckle (3) over lower ball joint stud and guide hub and bearing (2) onto axle half shaft (1).
3. Start NEW nut (4) on lower ball joint stud. Do not tighten at this time.