Charger V6-3.5L VIN G (2006)
5. Distribute ½ the amount of grease provided in seal boot service package (DO NOT USE ANY OTHER TYPE OF GREASE) into outer C/V joint
assembly housing. Put the remaining amount into the sealing boot.
6. Install outer C/V joint sealing boot to interconnecting shaft clamp evenly on sealing boot.
7. Clamp sealing boot onto interconnecting shaft using crimper, Special Tool C-4975-A and the following procedure. Place crimping tool C-4975-A
over bridge of clamp. Tighten nut on crimping tool C-4975-A until jaws on tool are closed completely together, face to face (2).
CAUTION: Seal must not be dimpled, stretched, or out-of-shape in any way. If seal is NOT shaped correctly, equalize pressure in seal and shape
it by hand.
8. Position outer C/V joint sealing boot into its retaining groove on outer C/V joint housing. Install sealing boot to outer C/V joint retaining clamp
evenly on sealing boot.
9. Clamp sealing boot onto outer C/V joint housing using Crimper, Special Tool C-4975-A (3) and the following procedure. Place crimping tool
C-4975-A over bridge of clamp. Tighten nut on crimping tool C-4975-A until jaws on tool are closed completely together, face to face (2).
