Charger V6-3.6L (2011)
3. Remove clamp at end of hose where it connects to the heater tubing.
4. Install protective sleeve onto new hose.
5. Install clamp 5 mm from the end of hose where it connects to the heater tubing.
6. Fill cooling system. Following the detailed procedures found in DealerCONNECT > TechCONNECT > 07 Cooling > Standard Procedure - Adding
Additional Coolant.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.