Charger V8-5.7L (2008)
NOTE: For vehicles equipped with the optional Automatic Express Up power window feature, calibration of this feature is required
whenever power to the door module is disrupted.A battery reconnect procedure must be performed anytime the battery has been
disconnected. See: Starting and Charging/Battery/Service and Repair/Procedures/Battery Reconnection.
13. Reconnect the battery negative cable.
Front Floor Foot Rest - Removal
REMOVAL
1. Remove the trim from the driver side lower cowl side inner panel. See: Cowl Trim/Cowl Trim - Removal.
2. Remove the three push-pin fasteners that secure the driver side front carpet to the cowl side inner panel and the front door opening sill.
3. Pull the front floor carpet up and away from the foot rest (1) far enough to access and remove the nut (2) that secures the foot rest to the weld stud
(5) on the front floor panel.
4. Lift the base of the foot rest upward far enough to disengage the tab (3) at the top of the foot rest from the slot (4) in the dash panel.
5. Remove the foot rest from the vehicle.
Front Floor Foot Rest - Installation
INSTALLATION
1. Pull the outboard edge of the driver side front floor carpet up and away from the floor far enough to position the foot rest (1) between the front
floor panel and the carpet.
2. Engage the tab (3) at the top of the foot rest into the slot (4) in the dash panel.
3. Position the hole at the base of the foot rest over the weld stud (5) on the front floor panel.
4. Install and tighten the nut (2) that secures the foot rest to the weld stud. Tighten the nut to 16 Nm (12 ft. lbs.).
5. Reposition the driver side front carpet to the cowl side inner panel and the front door opening sill and secure with three push-pin fasteners.
6. Reinstall the trim onto the driver side lower cowl side inner panel. See: Cowl Trim/Cowl Trim - Installation.
A-Pillar Trim Panel-Removal
REMOVAL
