dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Cowl Trim|Page 10828 > < Cowl Trim|Page 10826
Page 15
background image

2. Align the spring clip retainers on the lower edge of the upper C-pillar trim (3) with the installation holes in the quarter inner panel (1) and pull the

outboard rear seat belt webbing and lower anchor through the slot in the trim.

3. Rotate the top of the upper C-pillar trim upwards far enough to engage the locating pin (2) into the locating hole in the quarter inner panel.
4. Align the spring clip retainers on the trim with the slots in the quarter inner panel and (if equipped) the curtain airbag support.
5. Using hand pressure, press firmly and evenly on the trim over each of the spring clip locations until the retainers snap into place.
6. Reinstall the lower trim onto the inside of the C-pillar. See: Pillar Trim/C-Pillar Trim Panel-Installation.
7. Position the outboard rear seat belt lower anchor to the quarter inner panel.
8. Install and tighten the screw that secures the outboard rear seat belt lower anchor to the quarter inner panel. Tighten the screw to 32 Nm (24 ft.

lbs.).

9. Reinstall the rear seat cushion into the vehicle. See: Seats/Seat Cushion/Service and Repair/Seat Cushion / Cover - Installation.

Lower

LOWER

1. Check to be certain that the spring nuts (2) are properly installed and in good condition on the quarter inner panel (1). Replace the spring nut if any

damage is evident.

2. Position the lower C-pillar trim (5) onto the quarter inner panel with the lower edge sequenced over the rear extension of the rear door sill scuff

plate (6).

3. Install and tighten the two screws (4) that secure the lower C-pillar trim to the quarter inner panel. Tighten the screws to 1 Nm (11 in. lbs.).
4. Install and tighten the screw that secures the lower C-pillar trim to the rear shelf panel (3). Tighten the screw to 1 Nm (11 in. lbs.).
5. Reinstall the rear seat back side bolster onto the quarter inner panel. See: Seats/Seat Back/Service and Repair/Seat Back Cushion / Cover -

Installation.

6. Reinstall the rear seat cushion into the vehicle. See: Seats/Seat Cushion/Service and Repair/Seat Cushion / Cover - Installation.

Upper-Wagon

UPPER - WAGON

Cowl Trim|Page 10828 > < Cowl Trim|Page 10826