Charger V8-5.7L (2008)
Timing Cover: Service and Repair
Timing Cover - Installation
INSTALLATION
1. Clean timing chain cover and block surface.
NOTE: Always install a new gasket on timing cover.
2. Verify that the slide bushings (1) are installed in timing cover.
3. Install cover and new gasket. Tighten fasteners to 28 Nm (250 in. lbs.).
NOTE: The large lifting stud is torqued to 55 Nm (40 ft. lbs.).
4. Install the oil pan and pick up tubeSee: Engine Lubrication/Oil Pan/Service and Repair/Engine Oil Pan - Installation.
5. Install the A/C compressor.
6. Install the generator.
7. Install power steering pump.
8. Install the dipstick support bolt.
9. Install the thermostat housing.
10. Install crankshaft damperSee: Cylinder Block Assembly/Harmonic Balancer - Crankshaft Pulley/Service and Repair/Vibration Damper -
Installation.
11. Install accessory drive belt tensioner assembly and both idler pulleys.
