Charger V8-5.7L (2008)
4. Remove the two screws (1) that secure the flange (2) to the front of the HVAC housing (3).
5. Remove the flange and the heater core tubes (4) from the HVAC housing.
6. Disconnect the HVAC wiring harness (1) from the evaporator temperature sensor (2), blower motor resistor or power module (3) (depending on
application) and the blower motor (4).
7. Disengage the two HVAC wire harness retainers (5) from the blower motor and remove the blower motor from the HVAC housing See: Blower
Motor/Service and Repair/Removal.
8. Remove the blower motor resistor or power module, depending on application See: Blower Motor Resistor/Service and Repair/Removal or See:
Control Module HVAC/Service and Repair/Blower Motor Power Module - Removal.
9. Remove the evaporator temperature sensor See: Evaporator Temperature Sensor / Switch/Service and Repair/Removal.
10. Remove the two bolts (1) that secure the A/C expansion valve (2) to the evaporator tube tapping block located within the foam seal (3).
11. Remove the A/C expansion valve from the evaporator tube tapping block and foam seal.
12. Remove the O-ring seals from the evaporator tube fittings and discard.
