Charger V8-5.7L (2008)
NOTE: Always use a NEW O-ring on the end of the pressure hose.
2. Lubricate NEW O-ring on steering gear end of pressure hose with clean power steering fluid.
3. Install gear end of pressure hose (5) into steering gear port. Do not tighten tube nut at this time.
4. Route pressure hose along left side of engine cradle. Position pressure hose routing clamp, then install screw (7) through clamp, securing hose to
left side of engine cradle.
5. Route pressure hose along front of engine cradle. Install screw (2) through routing clamp securing hose to front of engine cradle.
6. Tighten pressure hose tube nut (5) at steering gear to 47 Nm (35 ft. lbs.).
7. Install belly pan. See: Body and Frame/Exterior Moulding / Trim/Underbody Cover/Service and Repair/Belly Pan - Installation
8. Lower vehicle.
NOTE: Always use a NEW O-ring on the end of the pressure hose.
9. Lubricate NEW O-ring on power steering pump end of pressure hose with clean power steering fluid.
10. 2.7L/3.5L Engines - Install pressure hose (2) to pump (1). Tighten pressure hose tube nut to 47 Nm (35 ft. lbs.).