Charger V8-5.7L (2008)
NOTE: Rear crossmember mounting bolts (2) are longer than front mounting bolts (3). Do not interchange mounting bolts.
6. Install crossmember mounting bolts (2 and 3). Snug, but do not fully tighten bolts at this time.
7. Measure distance (1) between from tension link (2) to body weld flange (3) directly in front of it, just outboard of front mount bushing (4). This
distance must be at least 12 mm to allow proper clearance for suspension movement. If distance is less than 12 mm, shift that side of rear
crossmember directly rearward until distance is 12 mm or greater. To do so, loosen 3 mounting bolts slightly, leaving one on opposite side of shift
snugged to pivot off of. Shift crossmember rearward and snug loosened bolts. Measure opposite side to be sure it also maintains minimum 12 mm
distance.
8. Tighten all crossmember mounting bolts (2 and 3) to 180 Nm (133 ft. lbs.).