Charger V8-5.7L VIN H (2007)
55. Install rear exhaust system (2) (dual-outlet exhaust shown in figure).
56. Lower vehicle until front tires contact floor but rear is still suspended. Place jack stands under each rear suspension spring link. Place an
appropriate wooden block between stand and link to avoid damaging spring link, then lower vehicle until full vehicle weight is supported by
suspension.
57. Tighten camber link bolt (2) at crossmember to 85 Nm (63 ft. lbs.).
58. Tighten tension link bolt nut (2) at crossmember to 85 Nm (63 ft. lbs.).