Charger V8-5.7L VIN H (2007)
1. If coupler and/or damper (V6 Models) were removed, align index marks and reinstall. Make sure protruding sleeve (2) is properly seated into
propshaft or damper counterbores.
2. Install three bolts with washers and nuts and torque to 58 Nm (43 ft. lbs.) torque.
3. Obtain helper and install propeller shaft into position at axle. Align index marks placed upon removal. Install propeller shaft rear coupler-to-axle
flange bolt/nuts by hand. Do not torque at this time.
4. Install propeller shaft into position at transmission flange. Align index marks placed upon removal. Install propeller shaft front
coupler-to-transmission flange bolt/nuts by hand. Do not torque at this time.