Charger SRT-8 V8-6.1L (2009)
to 2 Nm (16 in. lbs.). Fold and snap the screw cap over the screw.
8. Install and tighten the screw (5) that secures the trim panel (2) to the pull cup bracket below the trim panel pull cup. Tighten the screw to 2 Nm (16
in. lbs.). Fold and snap the screw cap over the screw.
9. Install and tighten the four screws (6) that secure the bottom and front lower corner of the trim panel to the inside of the door. Tighten the screws
to 2 Nm (16 in. lbs.).
10. Install the three push-pin retainers (1) that secure the trim panel to the inside of the door. See: Front Door/Description and Operation.
NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected. See: Starting and
Charging/Battery/Service and Repair/Procedures/Battery Reconnection .
11. Reconnect the battery negative cable.