Charger SRT-8 V8-6.1L (2009)
Hood Hinge: Service and Repair
Hood Hinge - Removal
REMOVAL
1. Open and support the hood (2) with a suitable prop or block.
2. If the vehicle is so equipped, disconnect the upper end of the gas support cylinder from the upper bracket of the hood hinge (3). See: Hood Shock /
Support/Service and Repair/Gas Prop - Removal.
3. Mark the location of the hood hinge upper bracket on the hood (2) inner panel to aid reinstallation.
4. Remove the two screws (1) that secure the hinge to the hood.
5. Mark the hinge lower bracket location on the inside of the front fender ledge (5) to aid reinstallation.
6. Remove the two screws (4) that secure the hinge to the fender.
7. Remove the hood hinge from the vehicle.
