Charger SRT-8 V8-6.1L (2009)
6. Position the latch (2) to the front of the crossmember (1).
7. Loosely install the two bolts (3) that secure the hood latch to the headlamp mounting crossmember.
8. Align the hood latch using the alignment marks previously indicated and tighten the hood latch bolts to 28 Nm (21 ft. lbs. ).
9. Install the horns onto the headlamp mounting crossmember. Tighten the bolts to 28 Nm (21 ft. lbs. ).
10. Connect the headlamp wire harness to the horns.
11. Install the headlamp units (1) See: Lighting and Horns/Headlamp/Service and Repair/Headlamp Unit - Installation.
12. Install the front fascia See: Bumper/Front Bumper/Front Bumper Cover / Fascia/Service and Repair/Front Bumper Fascia - Installation.
13. Reconnect the negative battery cable.
14. Carefully close the hood and verify hood latch and panel alignment. Adjust as necessary.
15. If equipped with ACC (Adaptive Cruise Control), module must be realigned. See: Cruise Control/Cruise Control Module/Adjustments
