Charger SRT-8 V8-6.1L (2009)
1. Remove the seat cover and cushion assembly See: Seat Cover/Service and Repair/Seat Cushion Cover - Removal
2. Cut the tie-straps holding the fore/aft motor, as necessary, and disconnect the electrical connector.
3. Remove the fore/aft motor and flex shafts from the bracket.
NOTE: Do not remove the fore/aft motor bracket before any adjustment of the tracks.
NOTE: If motor bracket is to severely bent, or if the fore/aft motor is damaged to the point step 10 can't be performed, proceed to Step 11.
Still read and follow Cautions and/or Notes between steps 4 and 10.
4. Measure from the front or rear track stop to the front or back of the adjuster track on each seat track.
5. Remove the long flex shaft from the motor and put it in a cordless drill. Insert other end in gear box on adjuster track. Adjust both seat tracks until
they are within +/- 2mm of each other at a low speed.
