Charger SRT-8 V8-6.1L (2009)
2. Install the fasteners (1) holding the motor to the seat adjuster (2). Tighten the screws to 5 Nm (44 in. lbs.).
3. Connect the motor electrical connector.
4. Install the seat cushion See: Seat Cover/Service and Repair/Seat Cushion Cover - Installation.
5. Clip the wire harness to cushion pan.
6. Install the seat assembly See: Service and Repair/Seat, Front/Seat - Installation.
7. Connect the battery negative cable.
8. Verify normal operation of the power seat assembly.
HEIGHT ADJUST MOTOR