Charger SRT-8 V8-6.1L (2009)
6. Install tire and wheel assembly (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.). See: Maintenance/Wheels and Tires/Service and
Repair/Removal and Replacement/Tires and Wheels - Installation
7. Lower vehicle.
8. Remove brake pedal holding tool.
9. Connect battery negative cable (2) to battery post. It is important that this is performed properly. See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery Reconnection
10. Bleed (1) the area of repair for the brake system. If a proper pedal is not felt during bleeding an area of repair then a base bleed system must
be performed.See: Brake Bleeding/Service and Repair
11. Road test vehicle making several stops to wear off any foreign material on brakes and to seat brake shoes.
Twin Pistion