Charger SRT-8 V8-6.1L (2009)
2. Remove wheel mounting nuts (3), then tire and wheel assembly (1).
NOTE: In some cases, it may be necessary to retract caliper piston in its bore a small amount in order to provide sufficient clearance between
shoes and rotor to easily remove caliper from knuckle. This can usually be accomplished before guide pin bolts are removed by
grasping rear of caliper and pulling outward working with guide pins, thus retracting piston. Never push on piston directly as it may
get damaged.
3. Remove lower caliper guide pin bolt. To do so, hold the guide pin (3) stationary while turning bolt (1).
4. Rotate caliper upward (1), exposing brake pads (2 and 5). Use care not to overextend brake hose when doing this or damage may occur.
5. Remove inboard (2) and outboard (5) brake pads from caliper adapter (4).
