Charger SRT-8 V8-6.1L (2009)
7. Install Upper caliper guide pin bolt (1). While holding guide pin (3) stationary tighten bolt to 60 Nm (44 ft. lbs.).
8. Install tire and wheel assembly (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.) (Police - 190 Nm (140 ft. lbs.)). See:
Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Installation
9. Lower vehicle.
10. Pump brake pedal several times to set pads to caliper and brake rotor.
11. Check and adjust brake fluid level in reservoir (1). See: Hydraulic System/Brake Fluid/Service and Repair
CAUTION: When NEW brake pads have been installed, keep in mind that braking effectiveness might be somewhat reduced during the first
brake applications following installation.
