Charger SRT-8 V8-6.1L (2009)
3. Place trim stick (4) between brake pad (2) and outer edge of rotor (3).
4. Using trim stick, slowly apply pressure against brake pad (2) until both pistons (on that side of caliper) are completely bottomed in bores of caliper
half.
NOTE: Repeat above procedure to opposite brake pad (1) and pistons as necessary.
5. Support spring link (1) using a transmission jack (5) or other appropriate jack. Raise spring link just enough to access brake caliper lower
mounting bolt (4) from above compression link (2).
6. Remove the lower and upper caliper mounting bolts (1).
7. Remove brake caliper (2) with pads from knuckle and brake rotor. Hang assembly out of way using wire or a bungee cord. Use care not to
