Charger SRT-8 V8-6.1L (2009)
NOTE: The horizontal M10 fasteners are 5 mm longer in length, and must be reinstalled in original locations.
NOTE: New M6 fasteners must be used when reinstalling the oil pan. Do not reuse the old M6 fasteners.
5. Align the rear of the oil pan with the rear face of the engine block, and install the M10 and M6 oil pan fasteners finger tight. Using the following
torque sequence, torque the M6 mounting bolts to 5 Nm (44 in.lbs.).
6. Using the following torque sequence, torque the M10 oil pan fasteners to 54 Nm (39 ft.lbs.).
7. Using the following torque sequence, torque the M6 oil pan fasteners to 12 Nm (106 in.lbs.).
8. Lower the engine into mounts using special tool 8534B.
9. Install the left side engine mount studs (3) and nuts. Torque the studs and nuts to Nm ( ft. lbs.).
