Charger SRT-8 V8-6.1L (2009)
1. Position the intake manifold.
2. Using the sequence shown, install the intake manifold retaining bolts and tighten the fasteners to 12 Nm (9 ft. lbs.).
3. Connect the electrical connectors for the following components:
-
Manifold Absolute Pressure (MAP) Sensor
-
Short runner valve (SRV)
-
Fuel Injector electrical connectors
-
ETC ( Electronic Throttle Control )
4. Connect the brake booster hose, purge hose, and make-up air hose (MUA ).
5. Install the air cleaner housing (1) and clean air tube (2).