Charger SRT-8 V8-6.1L (2009)
Air Door Actuator / Motor: Service and Repair
Mode Door Actuator - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions may result in accidental airbag deployment and possible serious or fatal injury.
NOTE: LHD model shown. RHD model similar
1. Disconnect and isolate the negative battery cable.
2. Remove the instrument panel silencer from the driver side of the instrument panel See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Silencer Panel - Removal.
3. Remove the screws (1) that secure the mode door actuator (2) to the driver side of the HVAC air distribution housing (3).
4. Remove the mode door actuator from the air distribution housing and disconnect the HVAC wire harness connector (4) and remove the actuator
from the vehicle.
