Charger SRT-8 V8-6.1L (2009)
14. Install air cleaner housing and inlet tube. See: Filters/Air Cleaner Housing/Service and Repair/Air Cleaner Body - Installation
15. Connect battery negative cable (2) to battery post. It is important that this is performed properly. See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery Reconnection
16. Fill and bleed power steering system. See: Steering and Suspension/Steering/Service and Repair/Power Steering System Bleeding
Rear Wheel Drive
REAR-WHEEL-DRIVE
1. Install pressure hose in engine compartment from underneath.
NOTE: Always use a NEW O-ring on the end of the pressure hose.
2. Lubricate NEW O-ring on steering gear end of pressure hose with clean power steering fluid.
3. Install pressure hose (2) to steering gear (1). Do not tighten tube nut at this time.
