Charger SRT-8 V8-6.1L (2009)
9. Remove any clips (3) retaining brake rotor (2) to wheel mounting studs.
10. Slide brake rotor (2) off hub and bearing (1).
11. Push inward on end of half shaft (2) until C/V joints bottom. This is necessary to give as much access to hub and bearing mounting bolts as
possible.
NOTE: It is important to keep suspension jacked up as requested in 6 to ease access to lower hub and bearing mounting bolts.
NOTE: Use a 3/8 inch drive wobble extension along with a Torx(R) socket to access and remove two top and lower front mounting bolt. Use a
standard 3/8 inch drive universal joint along with a Torx(R) socket to access and remove lower rear mounting bolt.
