Charger SRT-8 V8-6.1L (2009)
16. Push the rear lower seat cushion back and down and install the seat cushion.
17. Connect the negative battery cable.
18. Fill the fuel tank and check for leaks.
Left Side Module - Removal
LEFT SIDE MODULE
1. Release the fuel pressure, refer to the Fuel Pressure Release Procedure. See: Engine, Cooling and Exhaust/Engine/Cylinder Head Assembly/Fuel
Pressure Release/Service and Repair
2. Disconnect negative battery cable.
NOTE: The fuel level of the vehicle must be below 5/8 of a tank before you remove the module lock-rings. If it is above that you can spill fuel
in the vehicle.
3. Drain partial fuel from fuel tank through the filler tube. Use a hard nylon tube, with a 30° cut on the end, to push the check valve open to drain fuel
from tank.