Charger SRT-8 V8-6.1L (2009)
7. A heat shield (1) is used over the right engine mount (3). The heat shield must be removed to gain access to generator support bracket nut. Remove
two heat shield mounting bolts (2).
8. Loosen, but do not remove generator support bracket nut (4).
9. Remove bolt (3).
10. Unsnap plastic insulator cap from B+ output terminal.
11. Remove B+ terminal mounting nut at rear of generator. Disconnect terminal from generator.
12. Disconnect field wire connector at rear of generator by pushing on connector tab.
13. Remove lower generator mounting bolt (1).
14. Remove generator from vehicle.
