Charger SRT-8 V8-6.1L (2009)
5. Install heat shield (1) and two heat shield mounting bolts (2).
6. Snap field wire connector into rear of generator.
7. Install B+ terminal eyelet to generator output stud. Tighten nut to 13 Nm (115 in. lbs.).
8. Position transmission cooler line (2) and install transmission cooler line bracket bolt (1) to right crossmember (3).
9. Install lower splash shield.
10. Lower vehicle.
CAUTION: When installing a serpentine accessory drive belt, the belt MUST be routed correctly. The water pump may be rotating in the
wrong direction if the belt is installed incorrectly, causing the engine to overheat.
11. Install generator drive belt. See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and
Repair/Removal and Replacement/Serpentine Accessory Drive Belt - Installation.
12. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lbs.).
